Environmentally friendly, low water consumption effective chewing gum removal without the use of chemicals, does not lift sand from joints on block paving or grout on paved areas.

This is a steam gum remover with a large wire brush scrubbing tool designed to dissolve the gum.  The machine producers 180 degrees at a 10 bar pressure, it has a separate tank for clean water that can be filled whilst the machine is in use.  The power pack is a 4kw Honda generator which producers enough power, combined with the steamer to heat up to 180 degrees in just 15 minutes from cold.  This whole unit is fixed into a powder coated frame with 2 fixed wheels and 2 braked castor wheels for easy maneuverability, there is a storage bin on the top of the machine to contain all of the accessories.  This is ideally suited for councils, contractors and cleaning companies for town center paved areas where larger volume machines make to much mess.

Recommended for use with high pressure hot water cleaning......

Chewing gum contamination is a problem that is here to stay .  For years the search has been on to find the definitive gum removal system, many have been developed to remove this sticky problem, but none have provided the complete answer.

The traditional method of using a pressure washer lance is slow, painstaking and leaves a lot of mess to clean up afterwards, including the gum that has just been removed.

Now a unique accessory is available that not only removes the gum, but collects it at the same time the amazing gum blaster.

The gum blaster is easy to operate and can be used with most hot or cold pressure washers.